Dogfish Technology mSATA-250GB internal SSD
- Internal Solid Stat…
- Consumer
Dogfish Technology
M.2 2242 form factor fits tight laptop slots, delivers 1TB capacity via SATA with 570 MBps read and 500 MBps write speeds
Options 1TB M.2 2242
This 1 TB internal SSD uses the M.2 2242 form factor and a SATA III interface to deliver solid-state storage in a 22 mm by 42 mm footprint. It is built with 3D NAND QLC memory and an SMI controller for everyday computing workloads. The drive suits ultra-thin laptops, small-form-factor desktops and embedded boards that cannot accept longer modules.
Confirm the host device has an M.2 socket that accepts 42 mm modules and is wired for SATA signalling rather than PCIe. Check the motherboard or laptop manual for keying type and maximum supported capacity. Ensure the BIOS or UEFI firmware recognises SATA SSDs in the M.2 slot and that no physical obstruction blocks the 3.2 mm module height.
Sustained sequential reads reach 570 MB/s and writes reach 500 MB/s when transferring large files over extended periods. The 3D NAND QLC architecture and SMI controller maintain consistent performance without thermal throttling within the 0 °C to 75 °C operating range. MTBF is rated at 1,000,000 hours for long-term reliability.
| Brand | THREE COLOUR DOGFISH |
|---|---|
| Series | 2242-1TB |
| Model | 2242-1TB |
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | M.2 2242 |
| Capacity | 1TB |
| Memory Components | 3D NAND QLC |
| Interface | SATA III |
| Controller | SMI |
| Max Sequential Read | Up to 570 MBps |
| Max Sequential Write | Up to 500 MBps |
| MTBF | 1,000,000 hours |
| Operating Temperature | 0°C ~ +75°C |
| Storage Temperature | -45°C ~ +85°C |
| Operating Humidity | 0% ~ 95% |
| Height | 42MM |
| Width | 22mm |
| Depth | 3.2mm |
| Weight | 0.05g |
このモデルの他のバージョン
同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。
The drive is supplied as a bare M.2 2242 module. Most laptops and desktops include the single M2 screw; if yours is missing you will need to source one separately. No heatsink is required or included for this SATA III model.
QLC flash stores four bits per cell, so the 1TB capacity delivers the highest density in the 22mm x 42mm footprint. The SMI controller manages wear-levelling and SLC caching to keep the 570 MB/s read and 500 MB/s write figures consistent across the full capacity.
In a typical SATA III 6 Gb/s slot you will see sequential reads near 570 MB/s and writes near 500 MB/s on large files. Random 4K performance and sustained write speed after the SLC cache fills will be lower, but everyday boot and application loads remain well within SATA III limits.
同じ売り場の商品
同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。
お支払いに使うコインと、価格表示に使う通貨です。
チェックアウト時にウォレットから送信されます。
表示のみ—カタログの価格は米ドル建てです。
該当する通貨がありません。
サイトの表示言語を選択してください。
一致する言語がありません。
初めてのご利用ですか?
すでにお持ちですか?
自動的な再設定はありません。当店はメールを送信しないため、ワンタイムリンクをお送りすることもできません。アカウントにメールアドレスを残しておいていただければ、担当者が手作業で確認いたします。
リクエストを受け付けました
受信箱に何かが届くことはありません — 当店はメールを一切送信していません。担当者が手作業で確認いたします。
思い出しましたか?