Enfain
Enfain OM3 LC-FC Duplex Multimode Fibre Optic Cable 30m Aqua Blue
A 30-metre OM3 multimode duplex patch cable with LC and FC connectors, ceramic ferrules and a 3.0 mm aqua jacket rated for 10 Gbit/s at 850 nm with typical insertion loss of .2 dB
- Low insertion loss with typical .2 dB and maximum .3 dB
- High return loss exceeding 38 dB for signal integrity
- OM3 core supports 10 Gbps over 30 m distance
- 0 mm PVC jacket rated for -20°C to +60°C operation
- Ceramic ferrules tested for 1000 mating cycles
30-metre OM3 duplex patch cord
This Enfain OM3 multimode fibre cable spans 30 metres with LC and FC connectors at each end. The aqua-blue 3.0 mm PVC jacket protects a 10-gigabit core operating at 850 nm. It suits data-centre links, server rooms and switch uplinks that require duplex multimode connectivity.
Sustained-link performance
Typical insertion loss is .2 dB and never exceeds .3 dB, while return loss stays above 38 dB across the full length. The cable tolerates a 330 mm bend radius and is rated for 1000 mating cycles without degradation. Operating temperature spans from minus 20 °C to plus 60 °C.
OM3 10-gigabit core at 850 nm
The single specification that determines compatibility is the OM3 10-gigabit core tuned for 850 nm transmission. Installations needing single-mode fibre, higher bandwidth grades such as OM4, or connector types other than LC-FC will require a different cable.
Highlights
- Low insertion loss with typical .2 dB and maximum .3 dB
- High return loss exceeding 38 dB for signal integrity
- OM3 core supports 10 Gbps over 30 m distance
- 0 mm PVC jacket rated for -20°C to +60°C operation
- Ceramic ferrules tested for 1000 mating cycles
Specifications
No published specifications for this item yet.
Other versions of this model
5 more in the same range
Same family, different memory, cooler or clock — compare before you commit.
Questions about this item
Does the 3.0 mm jacket add noticeable heat or power draw when the link runs continuously?
The passive fibre draws no power and generates no heat; only the active transceivers at each end consume electricity.
What connectors must my existing equipment provide for this LC-FC duplex cable to plug in directly?
One side needs an LC port and the other an FC port; both must be multimode interfaces operating at 850 nm.
Will the OM3 10-gigabit core work reliably with legacy 1 Gbit transceivers I still use?
Yes, the OM3 core is specified for 1G, 10G and 40G compatibility, so older 1 Gbit modules function normally.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics








