Zyvpee
Zyvpee KDE1206PHV3 60x15mm 12V 0.6W 2-pin case fan
A 60 mm by 15 mm maglev case fan running on 12 V at 0.6 W with a 2-pin connector
- TypeCase Fan
- CompatibilityCase
- Bearing TypeMaglev
- Power Connector2 Pin
- ColorBlack
- LEDNon-LED
- Maglev bearing reduces friction for quiet operation
- 12 V DC input draws only .6 W of power
- Compact 60 x 15 mm frame fits tight chassis spaces
- Simple 2-pin connector enables quick installation
- Black non-LED design keeps build aesthetics clean
60 mm Maglev case fan
The Zyvpee KDE1206PHV3 is a 60 by 15 millimetre DC fan that runs on 12 volts and draws 0.6 watts through a two-pin connector. Its Maglev bearing reduces friction for quieter operation. The black, non-LED frame suits standard case mounting points. It is built for compact chassis airflow.
Suits tight builds needing low power draw
This fan fits small-form-factor cases and replacement spots where a 60 mm frame is required. The two-pin header offers only voltage control, so builders who need PWM speed curves should look elsewhere. Systems demanding higher static pressure or larger diameters will need a different model.
Steady airflow with minimal vibration
Under continuous load the Maglev bearing maintains consistent rotation without the wear of sleeve or ball designs. The 0.6 watt draw keeps heat contribution low during extended runs. Expect stable RPM and noise levels once the motor settles. The square frame aligns securely for sustained vibration-free cooling.
Pontos fortes
- Maglev bearing reduces friction for quiet operation
- 12 V DC input draws only .6 W of power
- Compact 60 x 15 mm frame fits tight chassis spaces
- Simple 2-pin connector enables quick installation
- Black non-LED design keeps build aesthetics clean
Especificações
| Series | KDE1204PKV3 |
|---|---|
| Model | KDE1206PHV3 |
| Type | Case Fan |
| Compatibility | Case |
| Bearing Type | Maglev |
| Power Connector | 2 Pin |
| Color | Black |
| LED | Non-LED |
| Features | DC square Cooler |
| Dimensions | 60*15mm |
Perguntas sobre este artigo
What power connector does my motherboard or fan controller need to run this 2-pin 12V fan?
The fan uses a standard 2-pin connector that plugs into any 12 V DC fan header on a motherboard or a compatible fan controller.
Will the 60 mm by 15 mm frame fit alongside the 120 mm fans already in my case?
Yes, the 60x15 mm footprint is much smaller than a 120 mm fan, so it can occupy tight spots such as VRM heatsinks, chipset coolers or narrow drive cages without interfering with larger fans.
How can I confirm the Maglev bearing is spinning correctly after installation?
Power the system and listen for smooth, quiet rotation; the magnetic levitation bearing should run without grinding or rattling, and you can verify RPM in BIOS or monitoring software if the header supports speed reporting.
Também nesta secção
Os clientes também compararam
Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.
