Enfain
Enfain OM3 ST-ST Duplex Multimode Fiber Patch Cable 15m Aqua Blue
OM3 multimode duplex patch cable with ST connectors, 15 m length, 3.0 mm jacket, 850 nm wavelength, 0.2 dB typical insertion loss, >38 dB return loss
- Supports 10 Gb links with OM3 10-gigabit core
- Low 0.2 dB typical insertion loss preserves signal strength
- High >38 dB return loss cuts back-reflection
- Durable 3.0 mm PVC jacket rated for 1000 mating cycles
- Operates from -20 °C to +60 °C for data-centre use
Enfain OM3 Duplex Patch Cable 15m
This 15-metre duplex multimode patch cable uses an OM3 10-gigabit core with ST connectors on both ends. It operates at an 850 nm wavelength and is built for 1 G, 10 G and 40 G Ethernet links in switches, servers and data-centre racks.
Sustained 10G and 40G throughput
Typical insertion loss is 0.2 dB and maximum insertion loss is 0.3 dB, while return loss exceeds 38 dB. These figures stay stable over long runs, so the link keeps its error budget during continuous high-speed traffic rather than only in short bursts.
PVC jacket, ceramic ferrules, wide temperature range
The 3.0 mm PVC jacket protects the fibres and the ceramic ferrules withstand 1000 mating cycles. The cable is rated for an operating range of -20 °C to +60 °C and a minimum bending radius of 330 mm, so it handles normal rack routing without excess attenuation or mechanical fatigue.
주요 특징
- Supports 10 Gb links with OM3 10-gigabit core
- Low 0.2 dB typical insertion loss preserves signal strength
- High >38 dB return loss cuts back-reflection
- Durable 3.0 mm PVC jacket rated for 1000 mating cycles
- Operates from -20 °C to +60 °C for data-centre use
사양
이 상품에 대해 아직 공개된 사양이 없습니다.
이 모델의 다른 버전
같은 라인업에서 5개 더
같은 제품군에서 메모리·쿨러·클럭이 다릅니다 — 결정 전에 비교해 보세요.
이 상품에 대한 질문
Does the 3.0 mm PVC jacket and 330 mm bend radius limit heat buildup when the 15 m cable runs continuously at 850 nm?
The cable operates from -20 °C to +60 °C with a 330 mm minimum bend radius, so normal rack routing will not cause heat-related degradation.
Which patch panels or switches must already have ST connectors to plug this duplex OM3 cord straight in?
Any device or panel with ST ports — such as legacy switches, servers or distribution frames — will accept the duplex ST connectors directly.
Will the 0.2 dB typical insertion loss at 850 nm cause errors on 1 Gbit links that share the same path?
Typical loss is 0.2 dB and maximum 0.3 dB at 850 nm, well within the margin for 1 Gbit and 10 Gbit multimode links.
이 진열대의 다른 상품
고객들이 함께 비교한 상품
같은 진열대, 같은 체크아웃 — 코인 8종, 환율 잠금 30분.
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics








