NEMIX RAM 96GB DDR5 5600 CL46 2Rx4 ECC RDIMM Supermicro H14DSG-O-CPU memory upgrade
- 96GB
- 288-Pin DDR5 RDIMM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
NEMIX RAM
128 GB DDR5-4800 registered ECC kit (2×64 GB, CL40, 1.1 V, 2Rx4) validated for Supermicro H13SSH-E
Size 128GB 2X64GB
This 128GB kit uses two 64GB DDR5-4800 RDIMMs built to the exact rank, voltage and timing the Supermicro H13SSH-E memory controller expects. It is intended for administrators expanding a single compatible server to its full registered ECC capacity.
The modules are 288-pin registered DIMMs, not UDIMMs or SODIMMs, so they match the board's required form factor and population rules. Registered buffering lets every slot run fully populated at the rated 4800 speed while ECC corrects single-bit errors before they reach the operating system.
Registered architecture offloads the memory controller during continuous workloads, maintaining rated throughput without the throttling seen on unbuffered alternatives. ECC protection operates on every cycle, preventing silent data corruption that would otherwise accumulate over long production runs.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Server Memory |
| Model | DDR5 ECC RDIMM Registered Server Memory |
| Part Number | MR38400-924K2 |
| Capacity | 128GB (2 x 64GB) |
| Type | 288-Pin DDR5 RDIMM |
| Speed | DDR5 4800 (PC5 38400) |
| CAS Latency | CL40 |
| Voltage | 1.10V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 ECC RDIMM Motherboard Compatible |
| Package Content | 128GB 2X64GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT |
Other versions of this model
Same family, different memory, cooler or clock — compare before you commit.
The modules are specified at 1.10V and use registered ECC architecture, which reduces electrical load on the memory controller so each DIMM can run at its rated voltage even in a fully populated configuration.
The kit has no heat spreader and draws only 1.1V at DDR5-4800 speeds; registered buffering keeps per-module power low, so thermal output is minimal and there are no moving parts to generate noise.
The modules are an exact-match upgrade validated for the H13SSH-E motherboard; consult your system manual for the approved DIMM population order and any firmware updates the vendor recommends.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?