A-Tech 2GB DDR2 667MHz SODIMM PC2-5300 CL5 1.8V 200-Pin laptop RAM
- 2GB
- 200-Pin DDR2 SO-DIMM
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
Dual-channel 4 GB kit of DDR2 533 MHz SO-DIMM modules for compatible laptops and all-in-one computers
Capacity 4GB (2 x 2GB)
Speed DDR2 533 (PC2 4200)
This 4 GB kit contains two 2 GB DDR2 SO-DIMM modules that run at 533 MHz with a CAS latency of CL4. It is built for laptops, notebooks and all-in-one computers that accept 200-pin DDR2 memory and need a straightforward capacity increase.
The matched pair enables dual-channel operation on systems with two available SO-DIMM slots, freeing a single slot if the board has three or leaving both slots filled on two-slot designs. Each module operates at the standard 1.8 V DDR2 voltage and is non-ECC unbuffered, so it fits the electrical requirements of mainstream DDR2 mobile platforms without registration or error-correction overhead.
At 1.8 V the modules draw the normal power envelope for DDR2 SO-DIMM parts, producing modest heat that is handled by the laptop's existing thermal solution. No additional cooling or higher-wattage power supply is required beyond what the original system provides for its memory subsystem.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR2 Laptop Memory RAM |
| Capacity | 4GB (2 x 2GB) |
| Type | 200-Pin DDR2 SO-DIMM |
| Speed | DDR2 533 (PC2 4200) |
| CAS Latency | CL4 |
| Voltage | 1.80V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Multi-channel Kit | Dual Channel Kit |
| Recommend Use | AMD & Intel Compatible |
إصدارات أخرى من هذا الطراز
نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.
The kit runs at DDR2 533 (PC2-4200) with CL4 latency; sustained bandwidth is capped at that rate, so heavy workloads will hit the memory throughput ceiling first.
Standard 1.8 V DDR2 SO-DIMMs generate modest heat; the modules are unbuffered and non-ECC, so thermal output stays low enough for typical laptop cooling.
Yes — the kit requires two 200-pin DDR2 SO-DIMM sockets and a chipset that can run dual-channel at 533 MHz.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟