暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料(保険付き)。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料(保険付き)。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン

NEMIX RAM

NEMIX RAM 576GB (6×96GB) DDR5 4800 ECC Registered RDIMM memory upgrade

SKU CH-ZJJ8-GTX25

A 576 GB DDR5 ECC registered RDIMM kit of six 96 GB modules running at 4800 MT/s with CL40 timing and 1.1 V operation, validated for the Supermicro H14DST-F motherboard

  • Capacity576GB (6 x 96GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes
  • 576 GB total capacity from six 96 GB modules for large-scale workloads
  • DDR5 4800 speed rated at PC5-38400 for high bandwidth
  • Registered ECC design with 2Rx4 organisation corrects single-bit errors on the fly
  • 1 V operation at CL40 latency matches the controller's exact timing
  • Verified fit for Supermicro H14DST-F using 288-pin RDIMM form factor

Exact-match server upgrade

This 576GB kit contains six 96GB DDR5 4800 Registered ECC RDIMMs built for the Supermicro H14DST-F motherboard. The 2Rx4 organisation, 1.10V operating voltage and CL40 timing match the board's memory controller requirements so the full capacity is recognised at rated speed. It is not suited to workstations or desktops that accept only unbuffered UDIMM modules.

Thermals and power

Registered buffering reduces the electrical load on the memory controller, allowing all slots to run fully populated without signal degradation. The 1.10V DDR5 baseline keeps per-module power draw low, and the absence of a heat spreader means airflow across the bare PCB handles normal server chassis cooling. No active cooling or extra voltage headroom is required for standard operation.

Build and connectors

Each module uses the 288-pin RDIMM form factor keyed for DDR5 server boards, so it cannot be inserted into UDIMM or SODIMM slots. The six-DIMM kit fills a typical multi-channel population sequence, but the exact slot order must follow the motherboard manual. Samsung, Micron or Hynix major-OEM DRAM chips are used depending on supply, all meeting the same registered ECC specification.

特長

  • 576 GB total capacity from six 96 GB modules for large-scale workloads
  • DDR5 4800 speed rated at PC5-38400 for high bandwidth
  • Registered ECC design with 2Rx4 organisation corrects single-bit errors on the fly
  • 1 V operation at CL40 latency matches the controller's exact timing
  • Verified fit for Supermicro H14DST-F using 288-pin RDIMM form factor

仕様

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-9624K6
Capacity576GB (6 x 96GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content576GB 6X96GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

このモデルの他のバージョン

同シリーズにさらに 5点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

How do I install the 288-pin DDR5 RDIMM modules in the Supermicro H14DST-F and what population order does the manual require?

The kit contains six 96GB 2Rx4 registered DIMMs; install them in the exact slot sequence shown in the H14DST-F manual so the memory controller recognises the full 576GB at DDR5 4800.

What ongoing maintenance or replacement will the 576GB DDR5 4800 ECC RDIMM kit need?

No scheduled maintenance is required; ECC corrects single-bit errors on the fly, and a module is only replaced if it develops uncorrectable faults.

What limit appears first when the 6×96GB 2Rx4 RDIMM kit runs sustained workloads at 1.1V?

The memory controller's maximum supported capacity and rank-per-channel limit is reached before thermal or voltage headroom becomes an issue.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。